VOTOU03GBD.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

MAKE VOLKSWAGEN MOD. TOUAREG YEAR 03 ﬁ

PETROL

DIESEL

ALARM/SIREN

POSITION

It is suggested the installation of modular antithefts, as the structure of the bonnet/engine

compartment does not allow enough space to install compact antithefts.

CENTRAL UNIT POSITION

Position the modular sistems and the modules under the dashboard, driver’s side.

POWER SUPPLY

+30: connect to the 4 mm 2 WHITE/RED wire located in a multiway connector in the fuse box

placed above the pedal accelerator.

-31: connect to the ground terminal located behind the driver’s side bulkhead.

IGNITION WIRE

+15/54: connect to the 1 mm 2 BLACK wire located in a multiway connector, in the fuse box

placed above the pedal accelerator.

DIRECTION INDICATORS

Positive control signal

Connect to the BLACK/WHITE wire at the position nr.1 of the 6 way LIGHT BROWN connector

and to the BLACK/GREEN wire at the position nr.4 of the 6 way blue connector coming out of

the central locking unit placed on the right of the steering column, under the driver’s side

dashboard.

Negative control signal

As alternative, it is possible to connect to the control wire of the 4 direction indicators located

in the wiring harness of the connector coming out of the 4 direction indicators push-button

located in the central tunnel. The control is with negative polarity, so you must add an

additional relay to invert the positive signal of the direction indicators control of the Cobra

antithefts.

ELECTRIC WINDOWS

Negative control signal

Connect to the 1 mm 2 YELLOW/BLUE wire located in the wiring harness of the grey connector

coming out of the windows operating central placed behind the covering inside the driver’s side

door.

CENTRAL DOORS LOCKING Negative control signal

Connect with the unlocking wire (ORANGE) and to the locking wire (VIOLET) of the antitheft

to the YELLOW wire in the wiring harness of the 3 way connector coming out of the

UNLOCK/LOCK original push-button of the vehicle located in the driver’s side oor. To make

the connection you must insert a 1500 Ohm resistor in serie to the VIOLET wire of the

antitheft.

IMMOBILISATION POINT

Gasoil pump

Cut the wire at the position nr.8 in the pink connector, on the left, located in the connectors

holder box placed in the driver’s side engine.

STARTER

+50: Cut the 2,5 mm 2 BLACK wire in the pink connector, on the left, located in the connectors

holder box placed in the driver’s side engine.

BONNET SWITCH

Connect to the wire located in the wiring harness coming out of the lock of the bonnet.

DOORS SWITCH

Connect to the wire coming out of the 2 way connector located in the lamp placed in the

bulkhead covering the centrals under the driver’s side dashboard.

BOOT SWITCH

Connect to the wire that actuates the lamp located in the rear boot.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

votou03gbd.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: