Guide.pdf

2004 – 2006 Prius Side Marker / HYBRID Emblem Template

First off I'm not responsible for any damage caused by using my template. This template servers as a

guide only! You are responsible for aligning and making adjustments to your installation. This template

is accurate to within 1/16 of an inch according to my 2006 Prius. I made the cut out a little small so you

can make a tight custom fit. I will not tell you how to install the side markers in this guide because I

had a body shop install mine. Its up to you on how to get everything installed and working. I'm just

providing you an estimated place to put them.

You may redistribute and copy this document as long as you give me credit.

Tools needed

1. Masking tape

2. Kite string

3. Xacto knife

4. Template

Installation of the template.

1. Print out the templates you need. Make sure when printing to print it out with NO STRECHING

and NO RESIZING. You may center the print if you like. After you make your print measure

the dimensions to make sure 1 inch equals 1 inch. If it does not match check your printer

settings and try again. You can now cut out the side marker with an Xacto knife. Just cut out

everything in the hatched out area. This will be the cut area. You may also cut out the HYBRID

at this time if your going to install the hybrid emblem.

For the 2006 template all you have to do is print it out NO STRECHING and NO RESIZING,

cut it out, align it with the HYBRID emblem and use some tape to secure it on your car. You

don't need to go any farther.

2. Prep your car by taping a piece of kite string on the back of the rear door handle like the picture

below. Make sure to center it vertically

String it all the way to the front of the car to where the bottom of the finder, the top part of the

bumper, and the light meet. Make sure this string is straight!

3. Put another piece of string where the front A pillar meets the finder. Get it in between the crack

and pull it straight down to the bottom edge of the wheel well. Make sure this string is straight!

4. Place the template behind the string and line up points A B C and D indicated on the

template. A and B are at the top and bottom. C and D are left and right. When you get your

strings centered with the lines A B C and D tape it and stand back and see if that where you

want it. Make things the way YOU want and when your done you can start cutting away.