Competition_Door_Install.pdf

Competition Door

Construction

Adding a Dynamat Door Kit to your vehicle is the single best car audio upgrade. A

Dynamat Door Kit will stop buzzes and rattles in the door, eliminate speaker panel

distortion and increase your speaker’s dynamic range. When building a competition

system, adding a door kit is just part of the job. Here is a four-part process for building a

competition door the Dynamat way!

Strip the door and clean the surfaces. Remove the door panel, the plastic moisture

barrier, removable brackets and speakers.

Step 1: Apply Dynamat Xtreme to the outer door skin.

Precut Dynamat Xtreme to fit the flat areas of the outer door

skin. Start from the top down and apply the material onto the

panel. This creates a sonic barrier that blocks outside noise.

It is recommended that you wear gloves and use a roller tool

for this step.

Step 3: Use Dynaplate to bridge holes and gaps.

For optimal sound quality and structural reinforcement, use

Dynaplate to bridge large holes and gaps on the inner door

skin. Dynaplate is incredibly strong and lightweight. You can

cover the entire panel or just cover the holes extending the

Dynaplate 1-1.5 inches onto the sheet metal. For maximum

performance, use two

layers. NOTE: Make sure

not to block or interfere

with the mechanical

operation of the door

such as the window and

lock mechanisms. Check

and double check for

proper operation.

Step 2: Install

Dynaxorb behind the

speaker location on the

outside door skin.

Dynaxorb stops speaker

back-wave energy which

greatly improves sound

quality.

Step 4: Apply a Dynamat Xtreme Door Kit to the inner

door skin. After Dynaplate, install a Dynamat Xtreme Door Kit

to the inner door panel. This will eliminate speaker panel

distortion, maximize the mid bass performance and increase

your effective amplifier power by lowering your vehicle’s noise

floor. As before, make sure not to block or interfere with the

mechanical operation of

the door such as the

window and lock

mechanisms. Check and

double check for proper

operation.

Step 5: Apply TacMat over the Door Kit. Apply TacMat

over the Dynamat Xtreme Door Kit to complete the door.

TacMat requires an adhesive for installation. Spray adhesive is

recommended. Roll up the window before you spray. Make

sure to not get the glue on areas like the window If you are

unsure, tape off the other areas first before spraying. Applying

TacMat will further reduce

road noise and maximize

sound quality.

Step 6: Finish your

installation with your

choice of speakers and

door trim. You now have

a big advantage and the

opportunity for incredible

sound!

DYNAMIC CONTROL

3042 Symmes Road • Hamilton, Ohio 45015

phone: 1-800-225-8133 • fax: 1-800-873-2423 • www.dynamat.com

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: