# # this config file was automatically generated # using lirc-0.6.1 on Fri Sep 1 22:34:30 2000 # # contributed by Bastian # # brand: pace # model: mss 300 serie # supported devices: ? # # Pace remote controls send two header signals before the acutal # code. The length of one header signal is approx. 750 3000. With the # chosen tolerance values LIRC confuses the header signals with a # 0. In this case this is ok, because otherwise you would have to # create a raw_codes config file that does not support toggle # bits. But it might cause problems if you want to send these signals. begin remote name pace bits 10 flags SPACE_ENC|CONST_LENGTH eps 30 aeps 100 one 658 6930 zero 658 4402 ptrail 661 pre_data_bits 2 pre_data 0x0 gap 121416 toggle_bit 3 begin codes 1 0x0000000000000301 2 0x0000000000000102 3 0x0000000000000303 4 0x0000000000000104 5 0x0000000000000305 6 0x0000000000000106 7 0x0000000000000307 8 0x0000000000000108 9 0x0000000000000309 0 0x0000000000000100 Up 0x000000000000031A Left 0x0000000000000116 Right 0x0000000000000311 Down 0x000000000000010B Menu 0x0000000000000317 Ok 0x000000000000011F Back 0x000000000000030F Red 0x000000000000010E Green 0x000000000000030C Yellow 0x0000000000000112 Blue 0x000000000000030D end codes end remote
crahd