IV35101GBDT.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

MAKE

IVECO

MOD.

351*

YEAR. 01 ﬁ

PETROL

DIESEL

* Models with original equipment keyless entry system.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens, on the support of the wheelhouse, passenger’s

side, in the engine compartment. Pass the cables through the original rubber sleeve located

in the bulkhead that divides the engine compartment from the passenger’s compartment,

passenger’s side.

CENTRAL UNIT POSITION

Position the modular system and the modules under the dashboard, driver’s side.

POWER SUPPLY

+ 30: connect directly to the positive end of the battery.

- 31: connect with a terminal directly to the car body.

IGNITION WIRE

+ 15/54: connect to the LIGHT BLUE/BLACK wire located in the wiring harness coming out of

the ignition key.

DIRECTION INDICATORS

Connect to the LIGHT BLUE wire marked 1129 and to the LIGHT BLUE wire marked 1123

located in the wiring harness coming out of the central placed under the steering wheel; to go

in it is necessary to take away the protection panel.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the GREEN wire.

Front window, passenger’s side:

cut the DURK GREEN wire.

These connections must be done on the coming out of the respective motors.

ACTIVAT./DEACTIVATION

CONTROLS

Connections antitheft/vehicle

Art.3800 Vehicle Position

YELLOW/BLACK PINK Operating central

GREY/BLACK Positive Supply in the fuse box

VIOLET Positive Supply in the fuse box

ORANGE Positive Supply in the fuse box

VIOLET/WHITE Positive Supply in the fuse box

ORANGE/WHITE Positive Supply in the fuse box

The central is marked VIM215/CRX and located behind the heating panel; to go in it is

necessary to take away the covering panel under the passenger’s side dashboard.

IMMOBILISATION POINT

Gasoil pump

Cut the GREEN/BLACK wire located in the wiring harness coming out of the connector of the

ignition key.

STARTER

+50: Cut the 2 mm 2 GREEN wire located in the wiring harness coming out of the connector of

the ignition key.

BONNET SWITCH

Install an additional switch on the headlamp support plate, driver’s side.

DOORS SWITCH

Connect to the wire, at the position nr.2, of the 3 way connector coming out of the lamp.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

iv35101gbdt.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: