Those who make it
1
The overlap width of the main body of the body is bent, and the point part is sticked together.
2
After the overlap widths of parts of the fender are bent, it installs it in the point part of the body.
3
The fender is sticked together.
4
The part of the windshield and the bonnet is pasted.
5
A rear side is assembled according to the procedure similar to the reception desk.
6
A right and left side step is installed.
7
The section structure when the body is seen forward becomes it like this.
8
Two triangular sticks are made.
9
Two triangular sticks are put on the chassis parts.
10
The chassis is put on the body. At this time, the edge is matched to the line of the chassis in front of the body. (Before and behind. )Please match the right and left to the edge of the side step. The bumper is gradually bent. The paste is lightly put up to the edge of the fender and, then, shape is steady.
11
The tire is assembled.
12
The tire is installed. Both sides respect where being possible to do is good because it is common must turn to the outside about the tire. Moreover, when the match eyes on the tire running side make it turn right above, the direction of the light of the wheel becomes complete.
mizia811