bolerko kimono - opis.pdf - szydelkowanie - mastalina

Pattern Pieces

1 Front and Back Piece 2x

2 Fringes

Copy Paper with DinA4 Print:

The pattern pieces are printed with a narrow border onto 20 pages. Wait until all pages are printed. Arrange

the pages as depicted in the page with instructions on how to put the pages together.

Cut the pages at the upper right edge along the narrow border. Start with the lower left page and glue the

pieces together at the border lines.

Choose the size of the pattern according to the Burda measurement chart. The sizes for dresses, Blouses,

Jackets and Coats are determined by the bust measurement, the sizes for pants and skirts are determined by

the hip measurement.

Adjust, if necessary, if your measurements differ from the Burda measurement chart.

Cut the pattern pieces for your size.

Cutting out

Fabric Fold (-----) means : This is the middle of a pattern pieces, not an edge or a seam. The piece is cut

twice the size of the pattern; the fabric fold is the middle axis of the piece.

The pattern pieces with interrupted outlines are placed onto the fabric with the printed side facing down.

The cutting plans show how to arrange the pattern pieces on the fabric.

If fabric is not folded, pin the pattern pieces on the right side.

If fabric is folded, the right side is facing inside. Pin pattern pieces onto the wrong side.

Cut the pieces that are placed over the selvage in the copy paper last, with the fabric not folded.

Cutting the Fringes:

Lengthen the strips for the fringes; in other words, draw part 2 onto the fabric until they add up to the total

length for your size. Cut pieces.

Seam and Hem Allowances are included in the pattern:

1.5 cm (5/8 inch) for all edges and seams.

With Burda copy paper, transfer the lines and marking on the pieces onto the wrong side of the fabric.

Instructions are included in the package.

BOLERO

Back Middle Seam

1.) Place Bolero pieces onto each

other, right sides facing, stitch back

middle seam. Iron seam allowances

in one direction. Trim the lower

seam allowance. Fold over and pin

the upper allowances and stitch

neatly (1a).

Side and Lower Sleeve Seams

2.) Fold bolero at the marked shoulder,

right side inside. Stitch side and

lower sleeve seams (seam number

4). Trim seam allowances and de-

baste them held together. Iron to

one side.

Fringes

⇒Mark seam allowances (1.5 cm or 5/8

inch) with basting stitches at the outer

jacket edge.

3.) Fold strips for fringes lengthwise,

iron the wrong side inside.

4.) Pin the selvage of the fringe strips

to the marked line of the outer

jacket edge and stitch with small,

narrow zigzag stitches. Fringe the

strips. Cut the seam allowances of

the jacket (4a).

Pin fringe strips onto the lower sleeve

edges in the same fashion and fringe them.

Pleats/ Lower Sleeve Edges

5.) Fold sleeves, right side inside.

Stitch other pleat lines onto each

other until you

Reach the pleat arrow. Secure seam

ends.

Iron pleat as with inverted pleats. Pin pleat

and stitch at the fringe stitching line (5a).

bolerko kimono - opis.pdf

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: