OPFRO00GBB.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

OPEL

MOD. FRONTERA YEAR 00 ﬁ

PETROL

DIESEL

MAKE

ALARM/SIREN

POSITION

Position the compact alarms and the sirens in the engine compartment, near the driver’s

side headlamp.

CENTRAL UNIT POSITION

Position the modular systems and the modules under the left side of the dashboard, driver’s

side.

POWER SUPPLY

+ 30: connect to the general power supply located in a multiway connector at the entrance

of the fuse box.

- 31: connect with a cable terminal directly to the car body.

IGNITION WIRE

+ 15/54: connect to the LIGHT BLUE/BLACK wire located in the 13 way connector near the

steering column.

DIRECTION INDICATORS

Connect to the GREEN/WHITE and GREEN/BLACK wires located in the 13 way connector

near the steering column.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the BROWN/RED wire located in the wiring harness coming out of the driver’s side

control switch.

Front window, passenger’s side:

cut the BROWN/RED wire located in the wiring harness coming out of the passenger’s side

control switch.

Rear window, driver’s side:

cut the BROWN/RED wire located in the wiring harness coming out of the driver’s side

control switch.

Rear window, passenger’s side:

cut the BROWN/RED wire located in the wiring harness coming out of the passenger’s side

control switch.

The above connections must be done inside of each door.

CENTRAL DOORS LOCKING

Negative control signal

Connect to the GREEN/RED wire (lock) and to the RED/BLUE wire (unlock) located in the

wiring harness coming out of the driver’s side door.

IMMOBILISATION POINT

Fuel pump

If the vehicle has the inertial switch, it is suggested to interrupt one of the two wires coming

out of the same.

STARTER

+ 50: Cut the BLACK/WHITE wire located in the 13 way white connector, under the driver’s

side dashboard, on the left of the steering column.

BONNET SWITCH

Install an additional switch on the headlamp support plate, near the original bonnet bumper

rubber.

DOORS SWITCH

Connect to the BLACK/WHITE wire located in the wiring harness coming out of the central

doors locking unit on the rear of the glove compartment, passenger’s side.

BOOT SWITCH

Connect to the wire located in the wiring harness coming out of the boot lamp.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

opfro00gbb.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: