Dell Inspiron 8200 service manual.pdf

SECTION 1

Removing and

Replacing Parts

Before You Begin

System Components

Hard Drive and Fixed Optical Drive

System Upgrades

Keyboard

Display

Microprocessor Thermal-Cooling Assembly

Microprocessor Module

Video Graphics Board

Palm Rest

Reserve Battery

System Board

Battery and Module Bay Latches

Battery Charger Board

LED Board

Fan

RJ-11/RJ-45 Module

Removing and Replacing Parts

SECTION 2

Before You Begin

Preparing to Work Inside the

Computer

CAUTION: Only a certified service technician should perform

repairs on your computer. Damage due to servicing that is not

authorized by Dell is not covered by your warranty. Read and

follow applicable safety instructions in the Owner’s Manual that

came with the computer.

CAUTION: Allow the computer to cool to room temperature before

working inside the computer.

NOTICE: To avoid damaging the computer, perform the following steps before

you begin working inside the computer.

1 Ensure that the work surface is flat and clean to prevent scratching the

computer cover.

2 Save any work in progress and exit all open programs.

3 Turn off the computer and all attached devices.

HINT: Before

turning off the computer,

ensure that the computer

is not in a power-

management mode.

4 Ensure that the computer is undocked.

5 Disconnect the computer from the electrical outlet.

6 To avoid possible damage to the system board, wait 10 to 20 seconds

and then disconnect any attached devices.

7 Disconnect all other external cables from the computer.

8 Remove any installed PC Cards or plastic blanks from the PC Card

slot.

9 Close the display and turn the computer upside down on a flat work

surface.

10 Remove the battery from the battery bay.

NOTICE: To avoid component damage, always remove any installed batteries

before you service the computer.

11 Remove any device installed in the module bay.

12 To dissipate static electricity while you work, periodically touch an

unpainted metal surface on the computer chassis.

13 Handle components and cards by their edges, and avoid touching pins

and contacts.

Before You Begin

Recommended Tools

The procedures in this document require the following tools:

• #1 magnetized Phillips screwdriver

• Small flat-blade screwdriver

• Microprocessor extractor

• Nonmarring plastic scribe

• Flash BIOS update program floppy disk or CD (provided when needed

to upgrade the BIOS)

Computer Orientation

back of computer

left

right

front of computer

Before You Begin

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: