VeloxREVIITiled.PDF

1/64" ply doublers on both

sides of fuselage (see side view)

6mm Depron Fuse

Molded Carbon Gear Legs

3/16" zipties

3/8"x3/8" Hardwood motor block

Groove block to fit carbon rod.

If using GWS 350 Drive, mount

block on Carbon rod so that the

prop/drive shaft is in the same

location as shown on plans.

Notes on the fuse:

If you are going for all out light weight, consider leaving

out the fuse spar. The side plates are strong enough for

anything in flight, but will not be quite as tough for rough

landings/crashes. Make sure to use 15-30 minute epoxy or

shoogoo for the main parts...5 min and foam CA are not

strongenough, and will crack under the torque.

Elevator Servo

(HS-56HB Shown)

4mm Carbon Spar