Installation_Instruction.pdf

(320 KB) Pobierz
<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.01//EN" "http://www.w3.org/TR/html4/strict.dtd">
How to upgrade the Software
1 Connect the AC power and turn “ON” the TV receiver.
2 The USB reader is located on the left or right of the cabinet near the side control/jack assembly as
shown in Figure1.
Figure1
3 Insert the “USB Drive” into the USB slot as shown in Figure2.
Figure2
4 After insertion of USB Drive into reader slot a firmware upgrade information window will appear as
shown in Figure3.
Figure3
5 If the window is no present, remove the USB Drive and try reinserting the USB Drive again.
Copyright 2010  All Rights Reserved  
Page  1  of  2  
861292793.014.png 861292793.015.png 861292793.016.png 861292793.017.png 861292793.001.png 861292793.002.png 861292793.003.png 861292793.004.png 861292793.005.png 861292793.006.png 861292793.007.png 861292793.008.png 861292793.009.png 861292793.010.png
6 Start the software upgrade by using the “left or right arrow” key of the remote control to select “Yes”.
7 Press “OK” key of the remote control to begin the upgrade.
8 The software upgrading process will begin. During the software upgrade, the TV receiver will display
“Updating… don’t AC power off” as shown in Figure4.
During this time, do not remove power to the television or press any remote keys or buttons
on the television until the upgrade is complete!
Figure4
9 Upon completion of the software upgrade a message will appear as shown in Figure5.
Figure5
10 Remove the “USB Drive” from the slot.
11 The TV will turn OFF and then, turn ON automatically.
12 Perform the “Initial Setup” and set “Personal Preference” of the TV.
Refer to your Owner’s manual should you have any questions.
Copyright 2010  All Rights Reserved  
Page  2  of  2  
861292793.011.png 861292793.012.png 861292793.013.png

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin