Installation Instructions and Activation
Install GlobalTis and during the installation click in all windows "Next"!!!
DO NOT CHANGE anything and leave all AS THEY ARE!!!
When installation finish, 1st DISABLE any Firewall that you have all ready enable!!! EVEN and Windows Firewall!!!
Run GlobalTIS and go and FILL Dealer info form (anything you wish...) BUT FULL filling!!!
Save your Dealer details
Click next till global tis is installed
Once installed double click desktop icon global tis
You will be requested to input some information and you must be connected to the internet at this time.
At the top of the page there is tab to edit dealer info.
Enter any information , make it up as not important up to you truth or lies
Enter any valid email address as email address you may get codes back to activate so you dont need to keep copying and pasting
then click save.
then back on first page activate online should be highlighted ,click on it
it will give you a request id r************
to make it work straight away use these codes underneath
Delete request id its put in and replace with these codes
you need to use all 3 as they match and will be easier if you make a little note pad with these codes in so you can access them easier
each time you want to activate it as it will only work till pc restarted with these 3 codes then you need to copy and paste again and it will work
till pc restarted
Requestid: r001121917
Subscriber-id: t001121918
License key:3285-6996-31be-6e7d-85c8-af03-91b4-c097-c59d-9578-7326-dd93-f317-56a8-92a2-4762
Then click on register licence key and it will error so log out
Then click on global tis icon again and hey presto it works and will work until pc restarted ,then if you need to use
Again just copy and paste 3 codes back in again and do same as above
First use you will need to install java plug in as prompted on first screen if you dont have java latest version on pc already but best
if you download latest version
You can install on as many pcs as you have using codes as above ,there is no gtee you will get 3 matched codes from gm as server is temperamental
and you may get them next day or next month or not at all and are not gteed .all i gtee is it works
Please note to enter codes you need to be connected to the internet for a few seconds
if you get the codes matched to the request id the software gave you it will work fully offline .
If using rs232 connection make sure your com port on pc is set to baud rate 115200 using device manager
then in global tis on each section ie tech 2 view it has a settings tab ,set that to same comport ,and settings on security and software update etc
you only need to do it once
Before updating tech 2 card make sure tech 2 view works and all settings are correct ,this is wher i can remote connect for you and do it all if needed
If you click on tech 2 view ,security or software download icons they each have a settings tab and each will need to be configured to that comport
If using usb to serial converter then cheap ones that work with tis 2000 dont tend to work with global tis we recommend belkin ,quite cheap about 25 gbp and work 100 percent
Before updating card on tech 2 please set it all up and test with tech 2 switched on and on main screen using tech 2 view icon to make sure of good connection then disconnect
Update tech 2 software using custom not standard and pick latest version then language you want it in
It takes about 20 mins to do software on card
Once software is updated click on security.machine will flash on and off four times and say security level 3 acccess enabled .this will need to be done quite often for tis aproval and sps
ENJOY..!!!!!!!!!!!!!!!
MAC331