K&N FIPK Gen 2 1991-1995 (57-1519).pdf
(
415 KB
)
Pobierz
57-1519 (17332A).qxp
INSTALLATION INSTRUCTIONS
Jeep
1991-95 Cherokee
L6-4.0L
PARTS LIST:
NOTE: This kit was not designed
to fit vehicles with a body lift.
Description
Qty. P/N
A Hose clamp #40
2
08554
B Silicone hose
1
08108
C Silicone hose 1/2 x 15-3/4”L
1
08414
D Silicone hose 1/2 x 3-1/2”L
1
087028
E Intake tube
1
087027
TOOLS NEEDED:
F Edge trim 39”L
1
102496
G Heat shield
1
07452
Flat blade screwdriver
13mm wrench
7/16” wrench
H Nut, 1/4-20 nylock
3
07517
I Washer, 1/4”
5
08275
J Bolt, 1/4-20 hex head
3
08386
K Washer, rubber
1
21685
L Washer, 1”od x 1/4”id
1
08160
M Washer, 1”od x .300”id
1
08130
N Washer, nylon
1
08281
O Bracket
1
070011
P Hose clamp #48
1
08061
Q Filtercharger
1
RC-4690
TO START:
1. Turn the ignition OFF and disconnect
the vehicle's negative battery cable.
2. Remove the crankcase vent line
from the valve cover.
7. Install the trim seal onto the heat
shield. Trim excess if needed.
11. Using the provided washers and the
hex nut removed in step 5, secure the heat
shield assembly to the existing stud as
shown.
3. Remove the EVAP canister vent line
from the air cleaner lid.
8. Using the provided hardware, secure
the “L” bracket to the heat shield as
shown.
12. Install the silicone hose and the
hose clamps onto the throttle body as
shown.
4. Loosen the hose clamp at the throttle
body and unclamp the airbox lid then
remove the upper intake assembly as
shown.
9. Install the heat shield assembly into
the vehicle lining up the factory stud with
the tab on the heat shield.
13. Install the K&N intake tube onto the
throttle body and tighten the hose clamp.
5. Loosen and remove the two bolts and one
hex nut that secure the lower air cleaner
assembly.
10. Using the provided hardware, secure
the “L” bracket to the inner fender as
shown.
14. Install the provided silicone hose onto
the crankcase vent, then install the other
end onto the K&N intake tube.
6. Remove the lower air cleaner assembly
as shown
57-1519
Continued
INSTALLATION INSTRUCTIONS
17. Reconnect the vehicle’s negative battery
cable. Double check to make sure everything
is tight and properly positioned before starting
the vehicle.
18. The C.A.R.B. exemption sticker, (attached),
must be visible under the hood, so that an emis-
sions inspector can see it when the vehicle is
required to be tested for emissions. California
requires testing every two years, other states
may vary.
15. Install the provided silicone hose
onto the EVAP canister vent line then
secure the other end onto the K&N
intake tube.
19. It will be necessary for all FIPK’s to be
checked periodically for realignment, clearance
and tightening of all connections. Failure to fol-
low the above instructions or proper mainte-
nance may void warranty.
16. Install the K&N Filtercharger onto
the K&N intake tube as shown.
ROAD TESTING:
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, find cause and
repair before proceeding. This kit will function
identically to the factory system except for being
louder and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and fix as necessary.
3. If road test is fine, you can now enjoy the
added power and performance from your kit.
4. K&N suggests checking the Filtercharger ele-
ment periodically for excessive dirt build-up.
When the element becomes covered in dirt (or
once a year), service it according to the instruc-
tions on the Recharger service kit, part number
99-5050 or 99-5000.
*FREE K&N DECAL To register your warranty, please see us online at knfilter.com/register. FREE K&N DECAL*
• 1455 CITRUS AVE., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX 951-826-4001
• e-mail: tech@knfilters.com • WWW: http://www.knfilters.com
17332a
1/18/05
Plik z chomika:
szymekZJ
Inne pliki z tego folderu:
Rusty's XJ Airtube.pdf
(92 KB)
RE 62mm Throttle Body (RE1062).pdf
(78 KB)
Poweraid 4.0L Throttle Body Spacer (310-510).pdf
(103 KB)
Poweraid 2.5L Throttle Body Spacer (310-511).pdf
(251 KB)
K&N FIPK Gen 2 1996-2001 (57-1518).pdf
(304 KB)
Inne foldery tego chomika:
Factory Service Manual
Parts Catalog
Skrzynie
Wewnątrz i z zewnątrz
Zawieszenie & Mosty
Zgłoś jeśli
naruszono regulamin