VeloxREVIITiled.PDF
(
197 KB
)
Pobierz
VeloxREVIIfull.pdf
1/64" ply doublers on both
sides of fuselage (see side view)
6mm Depron Fuse
Molded Carbon Gear Legs
3/16" zipties
3/8"x3/8" Hardwood motor block
Groove block to fit carbon rod.
If using GWS 350 Drive, mount
block on Carbon rod so that the
prop/drive shaft is in the same
location as shown on plans.
s
Notes on the fuse:
If you are going for all out light weight, consider leaving
out the fuse spar. The side plates are strong enough for
anything in flight, but will not be quite as tough for rough
landings/crashes. Make sure to use 15-30 minute epoxy or
shoogoo for the main parts...5 min and foam CA are not
strongenough, and will crack under the torque.
Elevator Servo
(HS-56HB Shown)
4mm Carbon Spar
Plik z chomika:
brzdmucel
Inne pliki z tego folderu:
VeloxREVIIfull.pdf
(146 KB)
VeloxREVIITiled.PDF
(197 KB)
Inne foldery tego chomika:
300LX (Grzegorrz)
Baby Baron (Grzegorrz)
BBAP2-60 (Grzegorrz)
Blu Baby (Grzegorrz)
Blu-Sail (Grzegorrz)
Zgłoś jeśli
naruszono regulamin